Author Topic: Timer script for autoperform buffer  (Read 4171 times)

chadox

  • Guest
Timer script for autoperform buffer
« on: December 09, 2004, 04:45:24 PM »
Hey all,

I have a

tiny problem with GameSurge.  All of the channels I communicate in are on the GameSurge IRC network.  When I connect to

GameSurge, I have my autoperform set to load up 11 channels automatically.  I used to have my channels in the AutoJoin List,

but I recently tried to move them to the AutoPerform Buffer to resolve my issue.  Moving them to the AutoPerform Buffer

hasn't worked either...

The problem?  The first 10 channels load up just fine... However, when the 11th channel goes

to load I receive the following message from GameSurge...

[19:24]

--NetFire.TX.US.GameSurge.net-- #channel11 :Target change too fast. Please wait 107 seconds.


Is

there a way to setup a timer to wait xxx amount of seconds before attempting to join the next channel?

My current

AutoPerform buffer looks similar to this...

/authserv auth my_username my_password
/mode

my_username +x
/join #channel01
/join #channel02
/join #channel03
/join #channel04
/join #channel05
/join

#channel06
/join #channel07
/join #channel08
/join #channel09
/join #channel10
/join

#channel11


Thanks in advance for the great ideas...

-ChadOx

Snerf

  • Administrator
  • Hero Member
  • *****
  • Posts: 1968
    • IceChat IRC Client
Timer script for autoperform buffer
« Reply #1 on: December 09, 2004, 05:02:20 PM »
Of course, using the /timer command.

Typing /timer on

its own gives the format for it, and its also under the "Commands" section of IceChat Help file.

So you can place the

1st ten in the AutoJoin list, and then just create a timer, with a slightly longer wait time, for each extra channel , in

AutoPerform.
The IceChat God

chadox

  • Guest
Timer script for autoperform buffer
« Reply #2 on: December 09, 2004, 09:23:16 PM »
Absolutely beautiful.  Works perfectly.  

Thanks!

-ChadOx